360° articulating clamp mount for smartphones AND tablets FROM 25.4 TO 35.5 cm WITH 360° POSITIONING AND INCLINING POSSIBILITY

STABILITY, SAFETY AND SIMPLICITY

Fastening clamp with tablet holder for aircraft.

This universal mount provides stability and security for your Tablet when you're using it in a plane or microlight.

This mount is ideal for GPS applications, giving you full access to your Tablet's various functions, as well as hands-free viewing with hyper-ergonomic portrait and landscape tilting.

Fastening is by manual screw tightening. Vibrations have little impact on your tablet, which is held securely and stays in place if you position the retention studs at opposite angles. Even in turbulent conditions, your tablet will remain firmly attached.

This clamp system also allows you to use it on an aircraft cockpit cap with an overhang. Use on a 2-axis microlight bar requires firm tightening to prevent the relative wind from turning the assembly.

Made in two parts, the screw fastener adapts to the thickness of your helm or cockpit cap. The 4 retaining studs are adjustable, and their diabolo shape, thanks to precise adjustment and firm tightening, will hold the shelf securely in place, eliminating any risk of it falling out.

ADJUSTABLE AND COMPATIBLE

This support allows you to easily orient your tablet in optimal position so that it is visible on one side without reflection and the touch screen perfectly accessible.

In both landscape and portrait mode, you can adjust the viewing angle to enjoy the mode that's right for you.

Compatible with all 10,8 cm jusqu'à 20,3 cm (3,94 à 8") tablets, Suitable for tablets with a width between 108 and 203 mm.

You can use it with an iPad Mini, Acer Tab, Touchlet SX7, Asus Google Nexus 7, Archos, HTC Flyer, Samsung Galaxy Tab 2 and Tab 3, Amazon Kindle, Motorola Xoom, Sony Tablet etc.

It has the advantage of not blocking the back of the tablet which allows better ventilation than if it is in a shell support.

The holding hooks allows large thickness so it also make it possible to use this holder with apparatus in a shell.

For temporary use, for example, in a flying club, the suction cup can be removed in a few seconds.

USE AND IMPLEMENTATION

Bond the adjustable support base and the suction cup base with the pivot ball provided for this purpose by unscrewing the ring, passing the rotation ball through the ring then inserting the ball in the 2 half cylinder then tighten the 2 half together
  - Clean the surface on which you will stick the suction cup, it is best that it be flat.
- Remove the protective film from the suction cup
- Press the suction cup firmly against the windscreen and fold down the locking lever (you can wet this suction cup with water or even saliva to ensure a better seal).
- Place your tablet and adjust the rubber clips of the holder so that it tightens it. The support must have both supports in the low position if you are in landscape mode.

TECHNICAL CHARACTERISTICS

• Universal tablet holder (Attention EITHER SUCCION CUP, EITHER CLAMP, only one type of fastening is delivered)
•   Powerful attachment: ultra-adhesive suction cup (Ø 89mm) with high vacuum and suction, with air release lever

Clamp fixing up to 3.5 cm thick

•   Extendable tablet support base (min: 108 mm - max: 203 mm)
•   Always under the eyes: Comfort and ease of use with adjustable angle of inclination and head adjustable to 360 °
•   Metal ball joint
•   Ideal for viewing your flight navigation application
•   Portrait or landscape mode
•   Compatible with tablets up to 3.94 or 8"
•   Suitable for smartphone and GPS (flat) or tablets with a width between 108 and 203 mm
•   Non-slip rubber foam cover to protect the device (claw clamp with soft rubber anti-slid and non-slip protection)
•   Vibration resistant
•   Dimensions & Weight: 150 x 215 x 113 mm, 166 g